More fibreglass fun.

So I must admit, direct progress on Bankruptcy V2 has stalled a little… but mainly because supporting work has been going on. What do I mean? Well alot of time on Bankruptcy V1 was taken… View Article

Published by: in Doing on the 20th July, 2015

Engine bay prep progress…

So this time around I’m cheating a little bit, I can’t get enough time off work to have any chance of getting Kara built up before show season…. so I’ve been turning to my friends… View Article

Published by: in Doing on the 28th January, 2015

Bankruptcy V2.0 “Kara”

Yeah I’m starting again…. a few reasons…. Insanity I want more cabin space, so i’m swapping the pedalbox and roll cage i found a teeny bit of rust I want a change in image for… View Article

Published by: in Announcements on the 01st January, 2015

A Fresh start….

Well… looking back, I’ve been a bit crap at updating this blog… Alot has happened since the last update nearly 3 years ago. And alot is going to change in the next few months too…. View Article

Published by: in Announcements on the 01st January, 2015

Front subframe off, and into the oven

Today i finished welding the engine bay up, then lifted her off the front subframe and slid her into Daves oven for spraying tomorrow morning. when i got her into the oven i laid the… View Article

Published by: in Doing on the 22nd March, 2012

Grinding and welding the engine bay

Today i managed to get a lot of the grinding and welding done in the bay, along with stripping out the pedal box and master cylinders for the brakes and clutch. not much more to… View Article

Published by: in Doing on the 20th March, 2012

Stripping her down

Last night was a bit of a late one, I got to Daves place after work about 8pm, with the aim of stripping the front end and puling the engine out. That way the car… View Article

Published by: in Doing on the 20th March, 2012

The start of “Super Bankruptcy”

This week i am starting “Super Bankruptcy”. This is a big refresh on the engine bay and the suspension, which will involve quite a bit of work. I’ll be removing the current master cylinders for… View Article

Published by: in Doing on the 19th March, 2012